The AirFlow Master Box is the central control unit for up to 4 AirFlow slaves, including control software for Windows XP-Win10 32/64bit. The Airflow Master has 4 separate connections for 2 x fans on the left and 2 x fans on the right. These are controlled separately. By means of the LED, the speed of the respective fans can be displayed depending on their luminosity. Optionally the LED display can be switched off. The control unit has a 'Curved Mode', so the fans are controlled alternately with more or less speed. This increases the curve feeling.
In desktop mode they can act as pure fans for cooling on the desktop and can be controlled separately via the software.
Console support: PS3, PS4, XBox360, XBox-One via UDP streaming. Attention: for UDP streaming a router and a PC must be available.
ATTENTION: Since in almost every household both a 12 Volt/1Amp. Power supply and a USB A to Mini-B cable is available in almost every household, the basic package does not include either cable.
Our recommendation: Use a 12V / 2 Amp. Power supply, because there is enough power reserve to change from 2 to 4 AirFlow-Slave later.
Each AirFlow Slave can be connected directly to the AirFlow Master (maximum 4 AirFlow Slaves) with only one connection cable. No additional cabling or power supply is required.
Each AirFlow Slave can be rotated forward/backward 90° and rotated 360°. Each AirFlow-Slave comes with a 1 meter long connection cable. (optionally it can be ordered with a 2 meter long cable)
Each AirFlow-Slave can be controlled separately as a fan in desktop mode via the software "AirFlow-Master-Control" and then serves as a pure fan module with infinitely variable speed.
ATTENTION: The AirFlow-Master Control Box is required to operate the AirFlow-Slave.
Each AirFlow-Slave is equipped with the Swiss Arctic fans PWM/PST in the size 92x92x25mm, 1800RPM, 12V with integrated control logic and high pressure performance with very low noise level at full load (1800 RPM)
By using the Plate-Mod, you can move the original pedalplates up to 15mm to the left and up to 15mm to the right. By turning the Mod-Plate, you can move the original plate height up or down by 15mm.
To get around the problem of bad pot pickup and the extremely large game, this Poti-Mod was developed. The Poti-Mod improves the scanning of the potentiometers. The cap included in the set prevents further soiling of the potentiometers. In the overall result we achieve a clean 100% scanning with this Poti-Mod, which results in a much finer dosage of the movement data.
With this pedal mod, you can set the spring force to any hardness. With these plates the spring travel can be shortened by max. 20mm. The package includes 2x3mm and 2 x 2mm thick insert plates, so you can shorten each side of a pedal by up to 10mm. To shorten 20mm travel 2 packages are needed.
With this adapter all Fanatec handlebars with and without Quick Release can be attached to the Logitech G25/G27/G29 Base. To use the buttons of the Logitech base the corresponding cable adapter must be selected additionally to use the corresponding board for the conversion of 2 or 6 buttons as well as the shift paddles.
The adapter consists of 2 parts. 1 times the adapter part which is screwed directly onto the Logitech base. 1 time the adapter with the steering wheel mount for Fanatec handlebars which is screwed to the 1st adapter.